hoststate.blogg.se

Wirecast 10 tetelestream tutorial 720p#
Wirecast 10 tetelestream tutorial install#

When the channel is running, right-click the channel name, navigate down to hover over Copy Input URL to clipboard and then select Primary Input Once the State has changed from Starting to Running, you can get the input URL. Navigate back to the AMSE tool, and check on the channel completion status. Get the channel's input URL in order to assign it to the Wirecast RTMP Endpoint. The Encoding field now has the newly created profile available for selection. Name the preset, and check for the following recommended settings:Īverage bit rate: 5000 kbits/sec (Can be adjusted based on network limitations) To customize these settings, select the gear icon to the right of the drop-down, and then choose New Preset.

Wirecast 10 tetelestream tutorial 720p#

The Encoding profile is pre-selected to Azure H.264 720p 16:9 (1280x720). On the settings page, set the Destination field to be Azure Media Services. Make sure the Output Destination is set to RTMP Server. Open the Telestream Wirecast application on the machine being used, and set up for RTMP streaming.Ĭonfigure the output by navigating to the Output tab and selecting Output Settings…. The rest of this section describes configuration steps in more detail. In this tutorial, the following output settings are used.

Configure the Telestream Wirecast encoder For more information, see Channel's states. Make sure the Start the new channel now is selected.īilling starts as soon as Channel goes into a ready state. Under Channel Settings, select Standard for the Live Encoding option, with the Input Protocol set to RTMP. Specify a channel name, the description field is optional. In the AMSE tool, navigate to the Live tab, and right-click within the channel area.

When using software-based encoders, close out any unnecessary programs.

While this is not a mandatory requirement, it helps mitigate the impact of network congestion.

A good rule of thumb when determining bandwidth requirements is to double the streaming bitrates.

Whenever possible, use a hardwired internet connection.

Launch the tool and connect to your AMS account.

Wirecast 10 tetelestream tutorial install#

Install the latest version of the AMSE tool.For more information, see Manage Streaming Endpoints in a Media Services Account Ensure there is a Streaming Endpoint running.Use the Wirecast version 13.0.2 or higher due to the TLS 1.2 requirement. Encoders must support TLS 1.2 when using RTMPS protocols.